MV

WIP! This page is a Work In Progress. You can help out by adding more information to the page.

Explosions, Part Two

In addition to the concerns from LV machinery, the addition of MV power means keeping higher voltage lines away from your low voltage cables and machines. Giving machines a higher voltage than they are rated for will make them explode. Putting MV power on a LV cable/wire will make it burn up, catch fire and potentially explode adjacent machines. To avoid a catastrophic failure by accidental over-voltage, separate LV and MV machinery rooms, use different cable sizes, and/or paint your cables.

Providing a lower voltage than a machine is rated for is safe. It may not be able to run all its recipes if it cannot be fed power fast enough, but there is no danger of fire or explosion. Many MV machine recipes can be run off LV power infrastructure with no issues, as they have very low EU/t requirements.

Transformers

thumb|right|Picture of a Transformer in default mode transferring 1 amp of HV into 4 amps of MV. The single dotted side is the MV outputs while the HV input is the bigger, hollow circle on the left sideOnce you have crafted your first EBF and started MV tier. You will gain access to producing MV (Medium Voltage, 128v) which is great! However. You will need to transform this energy into LV power to use it with your existing LV machines since LV Machines will explode if they are given too high voltage.

The Transformer allows you to convert GT Energy between voltage tiers. The big hollow circle is the Higher voltage side and is the front of the transformer, while the 5 smaller circles is the lower voltage sides.

By default the Transformer is taking 1 amp of higher voltage and transforms it into 4 amps of lower voltage. This is also called Step-Down mode. Ingame it will say “Machine Active” when toggling to this mode. You can also hit the transformer with a Soft Mallet to switch between its two modes. In Inverted mode, Step-Up mode (“Machine Inactive”), the Transformer will take 4 amps of lower Voltage and transform it into 1 amp of Higher voltage. Keep in mind that in this mode the lower voltage sides become the Input, and the higher voltage side is therefore the Output.

You should never change mode on a transformer that has power. Always disconnect cables before switching mode on the Transformers.

Power Transformer

The Power Transformer works like an ordinary transformer with one exception. It will accept 4 amps of higher voltage and turn it into 16 amps of lower voltage in its default mode. In inverted mode it will transform 16amps lower voltage to 4 amps of higher voltage.