Precise Auto-Assembler MT-3662: Difference between revisions

{{cleanup|missing exact placement & quantity limits for various hatches/busses, some infobox data. confirm compatibility with TecTech Laser Target Hatches and Multi-Amp hatches. Check if PA voids if outputs are full still post 2.5.0.}}

|tier=IVLuV

The assembler accepts different tiers of casing and will run recipes up to that [[tier]]. It supports TecTech Energy Hatches. The front and back have recessed glass panes enclosing a single block wide gap of air. The Precise Assembler cannot tier skip by using two Energy Hatches. Use the [[Multiblock Structure Hologram Projector]] to view the basic shape but note that it will not place any hatches, busses or the muffler.

* 1x Controller, front bottom, centered

* 1x Muffler, any casing location (?)

* +1x Input Hatch, any casing location

* +1x Output Hatch, any casing location (generally not required, as few if any recipes has fluid outputs)

* +1x Input Bus, any casing location

* +1x Output Bus, any casing location

* 1x Energy Hatch / Laser Target Hatch / TecTech multi-amp Energy Hatch maximum, any casing location

* x42+ Precise Electronic Unit Casings, minimum, remainder of structure (MK-I, MK-II or MK-III, must be all the same)

* 12x Tungstensteel Frame Box, all corners of three middle layers

* 21x Machine Casing, bottom layer interior, excluding outer edge (Not Machine Hulls!)

It can run in two modes: assembler and precise assembler and will run different recipes depending on the mode. As the assembler can run in only one mode at time, it's advised to build two. Right-click with a Screwdriver to switch between Normal and Precise modes. Provide logistics for the outputs so the multiblock won't shut down due to lacking output space.