Precise Auto-Assembler MT-3662: Difference between revisions
m
cleanup notes
m (→Usage: voids if output full / missing) |
m (cleanup notes) |
||
(5 intermediate revisions by the same user not shown) | |||
Line 1:
{{cleanup|missing
{{Infobox Test
|name=Precise Auto-Assembler MT-3662
Line 19:
== How to Build ==
The assembler accepts different tiers of casing and will run recipes up to that [[tier]]. It supports TecTech Energy Hatches. The front and back have recessed glass panes enclosing a single block wide gap of air. The Precise Assembler cannot tier skip by using two Energy Hatches. Use the [[Multiblock Structure Hologram Projector]] to view the basic shape but note that it will not place any hatches, busses or the muffler.
Requires:
* 1x Controller, front bottom, centered
* 1x Maintenance Hatch, any casing location
* 1x Muffler, any casing location
*
*
* +1x Input Bus, any casing location
*
* 1x Energy Hatch / Laser Target Hatch / TecTech multi-amp Energy Hatch maximum, any casing location
* x42+ Precise Electronic Unit Casings, minimum, remainder of structure (MK-I, MK-II or MK-III, must be all the same)
* 12x Tungstensteel Frame Box, all corners of three middle layers
* 42x Glass, two recessed wall panels, front and back (EV Tier, higher can be used but is purely an aesthetic choice.)
* 21x Machine Casing, bottom layer interior, excluding outer edge (Not Machine Hulls!)
== Usage ==
It can run in two modes: assembler and precise assembler and will run different recipes depending on the mode. As the assembler can run in only one mode at time, it's advised to build two. Right-click with a Screwdriver to switch between Normal and Precise modes. Provide
* In assembler mode it will run sinlge-block assembler recipes but in parallel.
|